Cateye PADRONE DIGITAL CC-PA400B Instruction Manual page 12

Setup with the PADRONE DIGITAL
3
Pair with a sensor.
Caution!:
•
To use the PADRONE DIGITAL, you have to pair it with a sensor that sup-
ports the Bluetooth® SMART standard.
•
Avoid pairing sensors at a race venue or in similar locations where there
are a lot of other users. Doing so may cause the PADRONE DIGITAL to be
paired with another device.
The unit switches to the pairing standby screen and Pr
flashes on the screen.
Use one of the methods in the following table to
activate the sensor.
CATEYE sensors
Speed/Cadence sensor
Heart rate sensor
* With the speed/cadence sensor and heart rate sensor, you can also activate the
sensor by pressing the RESET button.
Once pairing is complete, the name of the sensor is shown in the upper display.
* When pairing a sensor with the PADRONE DIGITAL, a "C" is displayed after the
sensor name.
4
To pair multiple sensors, hold down MODE to return to the
pairing standby screen.
Repeat step 3 to pair all the sensors that you intend to use.
Once you are finished pairing sensors with the unit, press
MENU to proceed to the next step.
Activating the sensor
Move the magnet through the sensor zone several times.
(Within 3 mm)
Rub both electrode pads with your thumbs.
12
Setting up the PADRONE DIGITAL
Re-verify
(press and hold)
MODE
MENU
Cover,
Introduction
Display
ISC
Hr
SET
Confirm
Appendix
1
2
Unit
2/4
3
4
5