Cateye PADRONE DIGITAL CC-PA400B Instruction Manual page 7

Mounting the speed/cadence sensor (ISC-12)
2
Temporarily attach the magnet.
Cadence
magnet
Sensor zone
(CADENCE) side
Nylon tie
(1) Using a nylon tie, temporarily attach the cadence magnet to the inside of the
left crank arm so that it faces the cadence sensor zone.
* If using pedals with steel axles, the cadence magnet can be attached mag-
netically to the pedal axle. In this case, remove the adhesive tape from the
magnet and do not use the nylon tie.
(2) Rotate the sensor arm and temporarily attach the wheel magnet to a spoke
facing the speed sensor zone.
* Reposition the sensor and the magnets if both magnets (speed and cadence)
cannot pass through their respective sensor zones.
Mounting the PADRONE DIGITAL
Sensor zone (CADENCE)
Sensor zone (SPEED)
7
Wheel magnet
Spoke
Sensor zone (SPEED) side
Cover,
Introduction
1
5/8
2
Using the unit
Using the app
3
4
SET
5
Appendix