Console Settings (Autobaud Rate Support) - Cisco 500 Series Administration Manual

Administration

Console Settings (Autobaud Rate Support)

STEP 3
Console Settings (Autobaud Rate Support)
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
- User Defined—Enter the hostname. Use only letters, digits, and hyphens.
Host names cannot begin or end with a hyphen. No other symbols,
punctuation characters, or blank spaces are permitted (as specified in
RFC1033, 1034, 1035).
• Custom Banner Settings—The following banners can be set:
- Login Banner—Enter text to display on the Login page before login.
Click Preview to view the results.
- Welcome Banner—Enter text to display on the Login page after login.
Click Preview to view the results.
When you define a login banner from the web-based configuration
NOTE
utility, it also activates the banner for the CLI interfaces (Console, Telnet, and
SSH).
Click Apply to save the values in the Running Configuration file.
The console port speed can be set to one of the following speeds: 4800, 9600,
19200, 38400, 57600, and 115200 or to Auto Detection.
If Auto Detection is selected, the device detects console speed automatically.
When Auto Detection is not enabled, the console port speed is automatically set to
the last speed that was set manually at (115,200 by default).
When Auto Detection is enabled but the console baud-rate has not yet been
discovered, the system uses speed 115,200 for displaying text (for example, the
boot-up information).
After Auto Detection is enabled in the Console Settings page, it can be activated
by connecting the console to the device and pressing the Enter key twice. The
device detects the baud rate automatically.
To enable Auto Detection or to manually set the baud rate of the console:
Click Administration > Console Settings.
Select one of the following:
• Auto Detection—The console baud rate is detected automatically.
6
106