Cisco 500 Series Administration Manual page 99

5
NOTE
97
• System Mode—Select either Layer 2 or Layer 3 mode.
Available only on devices where system mode can be selected.
NOTE
• Queues Mode—Select whether to configure 4 or 8 QoS queues on the
device. See Configuring QoS
If the device is an Sx500 and if the stack unit mode is changed from Native Stacking
to Standalone, the device will be in Layer 2 system mode after reboot, unless you
change the System Mode field to Layer 3 at this time.
Stack Topology View
This view displays how the devices in the stack are connected to each other.
When you click on the arrows connecting the devices, a tooltip displays the unit
number, the type of stack ports connected the units and the numbers of the
connected units. See an example of this below:
Administration: Stack Management
Queues.
Cisco 500 Series Stackable Managed Switch Administration Guide
System Modes