Configuring Scheme Authentication For Telnet Login - HP A7500 Series Configuration Manual

To do...
Configure the user privilege level
for login users
Configure common settings for
VTY user interfaces
When you log in to the device through Telnet again, perform the following steps:
You are required to enter the login password. A prompt such as <HP> appears after you enter the
•
correct password and press Enter, as shown in
If "All user interfaces are used, please try later!" is displayed, it means the number of current
•
concurrent login users exceed the maximum. Please try later.
Figure 14 Configuration page

Configuring scheme authentication for Telnet login

Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see "Configuration
Configuration procedure
Follow these steps to configure scheme authentication for Telnet login
To do...
Enter system view
Use the command...
user privilege level level
—
requirements."
Use the command...
system-view
Figure 14.
Remarks
—
40
Remarks
Required
0 by default.
Optional
See "Configuring common
settings for VTY user interfaces
(optional)."