Configuring Scheme Authentication For Telnet Login - HP 5120 series Configuration Manual

To do...
Enter system view
Enable telnet
Enter one or multiple VTY user
interface views
Specify the password
authentication mode
Set the local password
Configure the user privilege level
for login users
Configure common settings for
VTY user interfaces
When you log in to the device through telnet again:
You are required to enter the login password. A prompt such as <HP> appears after you enter the
•
correct password and press Enter, as shown in
If "All user interfaces are used, please try later!" is displayed, it means the number of current
•
concurrent login users exceed the maximum. Please try later.
Figure 10 Configuration page

Configuring scheme authentication for telnet login

Configuration prerequisites
You have logged in to the device.
Use the command...
system-view
telnet server enable
user-interface vty first-number
[ last-number ]
authentication-mode password
set authentication password { cipher |
simple } password
user privilege level level
—
Figure
40
Remarks
—
Required
By default, the telnet service is
disenabled.
—
Required
By default, authentication mode
for VTY user interfaces is
password.
Required
By default, no local password is
set.
Required
0 by default.
Optional
See "Configuring common
settings for VTY user interfaces
(optional)."
10.