Configuring Scheme Authentication For Telnet Login - HP 6125G Configuration Manual

Figure 14 Password authentication interface for Telnet login

Configuring scheme authentication for Telnet login

Follow these guidelines when you configure scheme authentication for Telnet login:
To make the command authorization or command accounting function take effect, apply an
•
HWTACACS scheme to the intended ISP domain. This scheme must specify the IP address of the
authorization server and other authorization parameters.
• If the local authentication scheme is used, use the authorization-attribute level level command in
local user view to set the user privilege level on the device.
If a RADIUS or HWTACACS authentication scheme is used, set the user privilege level on the
•
RADIUS or HWTACACS server.
To configure scheme authentication for Telnet login:
Step
1. Enter system view.
2. Enable Telnet.
3. Enter one or multiple VTY user
interface views.
4. Enable scheme authentication.
Command
system-view
telnet server enable
user-interface vty first-number
[ last-number ]
authentication-mode scheme
35
Remarks
N/A
By default, the Telnet service is
disabled.
N/A
Whether local, RADIUS, or
HWTACACS authentication is
adopted depends on the
configured AAA scheme.
By default, local authentication is
adopted.