HP A7500 Series Configuration Manual page 23

Follow these steps to configure the user privilege level under a user interface (SSH publickey
authentication type):
To do...
Configure the authentication type
for SSH users as publickey
Enter system view
Enter user interface view
Configure the authentication mode
for any user that uses the current
user interface to log in to the switch
Configure the privilege level for
users that log in through the current
user interface
Follow these steps to configure the user privilege level under a user interface (none or password
authentication mode):
To do...
Enter system view
Enter user interface view
Configure the authentication mode
for any user that uses the current
user interface to log in to the switch
Configure the privilege level of
users logged in through the current
user interface
Example of configuring a user privilege level under a user interface
# Perform no authentication on users logged in to the switch through Telnet, and specify their privilege
level as 1. (Use no authentication mode in a secure network environment.)
Use the command...
For more information, see Security
Configuration Guide.
system-view
user-interface { first-num1
[ last-num1 ] | vty first-num2
[ last-num2 ] }
authentication-mode scheme
user privilege level level
Use the command...
system-view
user-interface { first-num1
[ last-num1 ] | { aux | vty }
first-num2 [ last-num2 ] }
authentication-mode { none |
password }
user privilege level level
16
Remarks
Required if the SSH login mode is
adopted, and only username is
needed during authentication.
After the configuration, the
authentication mode of the
corresponding user interface must
be set to scheme.
—
—
Required
By default, the authentication
mode for VTY users is password,
and no authentication is needed
for AUX users.
Optional
By default, the user privilege level
for users logged in through the
AUX user interface is 3, and that
for users logged in through the VTY
interfaces is 0.
Remarks
—
—
Optional
By default, the authentication
mode for VTY user interfaces is
password, and no authentication is
needed for AUX login users.
Optional
By default, the user privilege level
for users logged in through the
AUX user interface is 3, and that
for users logged in through the VTY
interfaces is 0.