Configuring Cli Hotkeys - HP A7500 Series Configuration Manual

To do...
Enable the command alias function
Configure a command alias

Configuring CLI hotkeys

Follow these steps to configure CLI hotkeys:
To do...
Enter system view
Configure CLI hotkeys
Display hotkeys
NOTE:
By default, the Ctrl+G, Ctrl+L and Ctrl+O hotkeys are associated with pre-defined commands as defined
below, but the Ctrl+T and Ctrl+U hotkeys are not.
Ctrl+G corresponds to the display current-configuration command.
•
Ctrl+L corresponds to the display ip routing-table command.
•
Ctrl+O corresponds to the undo debugging all command.
•
Table 3 Hotkeys reserved by the system
Hotkey
Ctrl+A
Ctrl+B
Ctrl+C
Ctrl+D
Ctrl+E
Ctrl+F
Ctrl+H
Ctrl+K
Ctrl+N
Ctrl+P
Ctrl+R
Use the command...
command-alias enable
command-alias mapping cmdkey
alias
Use the command...
system-view
hotkey { CTRL_G | CTRL_L |
CTRL_O | CTRL_T | CTRL_U }
command
display hotkey [ | { begin |
exclude | include }
regular-expression ]
Function
Moves the cursor to the beginning of the current line.
Moves the cursor one character to the left.
Stops performing a command.
Deletes the character at the current cursor position.
Moves the cursor to the end of the current line.
Moves the cursor one character to the right.
Deletes the character to the left of the cursor.
Terminates an outgoing connection.
Displays the next command in the history command buffer.
Displays the previous command in the history command buffer.
Redisplays the current line information.
7
Remarks
Required
Disabled by default, which means
you cannot configure command
aliases.
Required
Not configured by default.
Remarks
—
Optional
The Ctrl+G, Ctrl+L and Ctrl+O
hotkeys are specified at the CLI by
default.
Available in any view. See
for hotkeys reserved by the system.
Table 3