Performing Batch Operations; Setting Prompt Modes - HP A7500 Series Configuration Manual

By default, a storage medium is automatically mounted when connected to the device. However,
•
when a storage medium is connected to a lower version system, the system cannot recognize the
storage medium. To perform read and write operations to the storage medium, you must mount it.
• An unmounted device is in the disconnected state, and can be removed safely. If you unplug a
storage medium without unmounting it, files on the storage medium or even the storage medium
may be damaged.
An unmounted storage medium can be used only when it is mounted again.
•
Follow a step below to mount or unmount a storage medium:
To do...
Mount a storage medium
Unmount a storage medium
CAUTION:
• When mounting or unmounting a storage medium, or performing file operations on it, do not unplug or
switchover the storage medium or the card where the storage medium resides. Otherwise, the file system
could be damaged.
Before removing a mounted storage medium from the system, unmount it to avoid damaging the storage
•
medium.

Performing batch operations

A batch file is a set of executable commands. Executing a batch file is the same as executing the
commands in the batch file one by one.
Before executing a batch file, edit the batch file on your PC, and then download it to the device. If the
suffix of the file is not .bat, use the rename command to change the suffix to .bat.
Follow these steps below to execute a batch file:
To do...
Enter system view
Execute a batch file
CAUTION:
Executing a batch file does not guarantee successful execution of every command in the batch file. If a
command has error settings or the conditions for executing the command are not satisfied, this command
fails to be executed, and the system skips to the next command.

Setting prompt modes

The system provides the following prompt modes:
Use the command...
mount device
umount device
Use the command...
system-view
execute filename
100
Remarks
Optional
By default, a storage medium is
automatically mounted and in mounted
state when connected to the system.
Optional
By default, a storage medium is
automatically mounted and in mounted
state when connected to the system.
Remarks
—
Required