Handlebar, Controls; Handlebar Position; Adjusting Handlebar Position; Checking The Routing Of The Throttle Cable - KTM 690 enduro R EU Repair Manual

7

HANDLEBAR, CONTROLS

7.1

Handlebar position

0 0 A A
0 0 B B
7.2

Adjusting handlebar position

1 1
1 0 0 1
0 0 2 2
2 0 0 2
7.3

Checking the routing of the throttle cable

On the upper triple clamp, there are 2 holes at a distance
Distance
A
The holes on the handlebar support are placed at a distance
Distance
B
The handlebar can be mounted in 4 different positions. In this way, the handlebar can
be installed in the position most comfortable for the rider.
400271-11
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two
screws .
2
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Fit and evenly tighten the four screws
Guideline
Screw, handlebar clamp
Preparatory work
–
Remove the seat. (
–
Take off the side cover. (
between holes 15 mm (0.59 in)
between holes 3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
1
. Remove the handlebar support.
2
M10
p. 64)
p. 65)
to each other.
A
from the center.
B
40 Nm Loctite
(29.5 lbf ft)
1
M8 20 Nm
(14.8 lbf ft)
33
® 243™
.