Multi-Function Terminals Wiring Example; Pr.47 Desired Frequency Attained - Danfoss 176F7300 Manual

Vlt micro

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

7. d06: AC Drive Control Mode – The Multi-function Output Terminal contacts will be

"closed" when the AC drive operation is controlled by the external terminals.

8. d07: Fault Indicator – The Multi-function Output Terminal contacts will be

"closed" when a fault is detected.

9. d08: AC Drive Control Mode – The Multi-function Output Terminal contacts will be

"closed" when the output frequency equals the Desired Frequency attained (Pr.47).

10. d09: PLC Program Running – The Multi-function Output Terminal contacts will be

"closed" the PLC program is executing.

11. d10: PLC Program Step Completed – The Multi-function Output Terminal contacts

will be "closed" within 5 seconds when each multi-step speed is attained.

12. d11: PLC Program Completed Execution – The Multi-function Output Terminal

contacts will be "closed" within 5 secs. after the PLC program completes execution.

13. d12: PLC Program Execution Paused – The Multi-function Output Terminal contacts

will be "closed" when the PLC program execution is paused by a multi-function input

terminal that has been programmed to pause the drive operation.

14. d13: Terminal Count Reached – The Multi-function Output Terminal contacts will be

"closed" when the counter value is equeal to the value programmed by Pr.96.

15. d14: Preliminary Counter Value Reached – The Multi-function Output Terminal

contacts will be "closed" when the counter value equeals the value of Pr.97.