Danfoss ICAD 600A Installation Manual

Hide thumbs Also See for ICAD 600A:

Table of Contents

Actuator

ICAD 600A /

ICAD 600A-TS

Fig. 1

Fig. 3

Fig. 5a, ICM + ICAD 600A/ICAD 600A-TS

ICAD 1200A

Note: When mounting the

ICAD make sure to push ICAD

down to mechanical stop.

2.5 mm

LB-feet

2.5

DKRCI.PI.HV0.K2.02 / 520H8962

ICAD 600A

ICAD 600A-TS

ICAD 1200A

Fig. 2

Fig. 4

in.

1.77

Fig. 5b, ICM + ICAD 1200A

Table of Contents

Need help?

Do you have a question about the ICAD 600A and is the answer not in the manual?

Page 1 Installation Guide Actuator ICAD 600A / ICAD 600A-TS / ICAD 1200A ICAD 600A ICAD 600A-TS ICAD 1200A ICAD 600A / ICAD 600A-TS ICAD 1200A Fig. 1 Fig. 2 Note: When mounting the ICAD make sure to push ICAD down to mechanical stop.
Page 2  Control cable Only possible with  Supply cable EKC 347  Supply cable EKE 347 Fig. 7 ICAD 600A/600A-TS/1200A - Digital I/O for ON/OFF valve operation Auxiliary relays Terminal box A (Black) B (Brown) C (Red) D (Orange) E (Yellow)
Page 3 II: White (+) 24 V d.c. Parameter list. III: Brown (–) 24 V d.c. ICAD configuration can be done ICAD 600A, ICAD 600A-TS and ICAD 1200A independently whether the ICAD is can be used together with the following Control cable with 8 poled M12 installed on the ICM valve or not.
Page 4 1) Power OFF and Power ON If A2 still active. 2) Make a Reset to factory setting If A2 still active. Return ICAD to Danfoss AI input error Alarm ON Not active if ¡01 = 2, or ¡02 = 2 When ¡03 = 1 and AI A >...
Page 5 If ¡26= 1 - 3 then factory settin qg = 100 Closing speed If ¡26= 4 - 9 then factory setting = 50 ¡15 When ¡01= 2, ¡15 determine the start up value. Manual set point to be continued..© Danfoss A/S (RC-MDP/MWA), 2014-10 DKRCI.PI.HV0.K2.02 / 520H8962...
Page 6 NB: Password protected. Password = 11  0: No valve selected. Alarm A1 will become active. 1: ICM 20 with ICAD 600A / ICMTS 20 with ICAD 600A-TS 2: ICM 25 with ICAD 600A 3: ICM 32 with ICAD 600A...

Icad 600a-ts Icad 1200a