Pr.76 Parameter Key; Pr.77 Reserved; Pr.78 Plc (Programmable Logic Controller) Operation Mode - Danfoss 176F7300 Manual

Pr.76 Parameter Key

Factory Setting d00
Units None
Settings d00 All parameters can always be set and read
d01 All parameters are read-only
d02-d09 Not used
d10 Resets all parameters to the factory defaults
This parameter controls the programming and read status for all parameters. Value d10
resets all parameters to factory settings.

Pr.77 Reserved

Pr.78 PLC (Programmable Logic Controller) Operation Mode

Factory Setting d00
Units None
Settings d00 Disable PLC program execution
d01 Execute one cycle of the PLC program
d02 Continuously execute program cycles
d03 Execute one cycle step by step
d04 Continuously execute program cycles step by step
This parameter controls PLC program execution: Pr.79 - 87.
VLT
53
® MICRO