First Time Installation And Configuration; Preparations; Unpacking And Installing The Rss 2000; Initial Rss 2000 Ip Configuration - Polycom RSS 2000 Getting Started Manual & Release Notes

Version 3.0.2

Hide thumbs Also See for RSS 2000:

Table of Contents

RSS 2000 Getting Started Guide & Release Notes – Version 3.0.2

First Time Installation and Configuration

Obtain the following information from your network administrator:

•

The system is shipped with a default IP configuration:

IP Address:192.168.1.254

Subnet Mask: 255.255.255.0

Gateway: 192.168.1.1

There are two ways to change the initial IP address of the sytem:

•

Changing the initial IP address via a cross over LAN cable

RSS 2000 unit, Subnet Mask and Default Gateway IP addresses

Gatekeeper IP address, Prefix, and E.164 of the RSS 2000.

Place the RSS 2000 unit on a stable flat surface in the selected location.

To connect to the power source, insert the power cable into the Power connector

on the rear panel of the MGC+ unit and insert the Power cable into the power

source socket.

Connect the LAN cable to LAN1 in the back of the system.

Turn on the power switch.

Via a cross over LAN cable

Via a RS232 or Telnet Console.

Connect a cross over LAN cable to LAN1 in the RSS 2000.

Set your laptop to the same segment of the RSS

For example (in your laptop IP config setting):

Table of Contents