Setting Image Display Mode - CDVI CD97-4ID User Manual

SETUP INSTRUCTIONS

Setting Image Display Mode

PLEASE NOTE: The following settings are only applicable for monitors that do not
support manual screen operation for pan-tilt, i.e. CDV47M, CDV43 and CDV24
When the monitor is being called:
When the door station calls a monitor, the camera image will be displayed on screen, there are
3 modes for the displayed image, Alternate switching mode, Zoom mode and Full screen
mode.
Alternate switching mode: when a monitor is called, the displayed image will switch between
Full screen and Zoom every 5 seconds.
Zoom mode: when a monitor is called, the displayed image will show full screen for 5
seconds, then switch to Zoom image.
Full screen mode: when a monitor is being called, the image displayed will be Full screen
only.
Alternate switching mode is the default setting, to change the setting, please follow the steps below:
In standby mode, press
KEY_SET button four
times.
UNLOCK Indicator:ON
TALK Indicator:ON
Buzzer
Beep+, Beep
• While in programming mode the image display setting can be changed by pressing KEY2 cyclically.
• The LED_NAME indicator will always flash while in programming mode.
• If there is no operation within 10 seconds, the door station will exit programming mode automatically.
• To exit programming mode, press KEY_SET button four times to exit manually.
When answering a call
When answering a call, an image switching reminder can be activated or deactivated.
If set to activated, the image switching reminder will be dependant on the image display mode set.
Alternate switching mode: When answering the call, the reminder does not operate.
Zoom mode: When answering the call, the image will be displayed on full screen for 5 sec-
onds then switching to the Zoom image as a reminder to enter talking status.
Press KEY_2 button to set
the image display mode
to Cycle switching.
UNLOCK Indicator:ON
TALK Indicator:ON
Buzzer
Beep+
Press KEY_2 button again
to set the image display
mode to Zoom mode.
UNLOCK Indicator:ON
TALK Indicator:ON
Buzzer
Beep, Beep
Press KEY_2
Press KEY_2 button again
and again to set the image
display mode to Full screen.
UNLOCK Indicator:ON
TALK Indicator:ON
Buzzer
Beep, Beep,Beep
-13-