VERITAS Velocity 7330 Hardware Installation Manual page 36

Make sure that the bottom of the disk is seated completely.
■
Push down slightly and start to pull the disk latch towards you. This action
■
moves the disk backwards. The connector on the right, rear, of the disk fits
into the pins in the rear of the slot.
Continue pulling the latch all the way down until it snaps in place under the
■
orange tab in the front.
Repeat this step for the remaining disk slots in the drawer.
6
After all 12 disks are installed, push the drawer back into the shelf and push
the orange latches inward to secure the drawer.
7
Repeat steps 4 -
Drawer 4, 3, 2, and then 1.
Installing disk drives into the Primary Storage Shelf
6 for the remaining drawers in the following order:
Installation procedures 36