Press Ergonomic Base - Dukane i220 User Manual

Press Ergonomic Base

The ergonomic base, shown in Figure 4-13, consists
of a base plate, cycle activation switches (black finger
switches), abort switch (red palm switch). At the back of
the base is a cable connector for an interface between the
i220 thruster and the base front panel.
Base Plate
The machined base plate is bolted to the top of the ergo-
nomic base. It has drilled and tapped holes that line up
with leveling screws in the fixtures to allow easy fixture
leveling for alignment with the horn. For details on the
alignment and leveling of the base plate, see Section 7:
Acoustic Stack/Fixture Setup.
NOTE
The actual amount of force applied to
the part depends on the following four
factors:
• The setting of the regulator(s)
• The area of the air cylinder
• The mass of the horn used
• The surface area of the horn
Left
Operate
Switch
Lower Fixture
Lower Fixture
E–Stop Switch
Figure 4-13 Ergonomic Base Controls
Dukane Manual Part No. 403-594-02
Figure 4-14 Right Operate Switch in Standby
Figure 4-15 Right Switch in Operate Mode, Both
Right
Operate
Switch
and ANSI requirements . Compliance
with all local building and electrical
codes is also required .
Dukane Corporation does not assume
any responsibility or liability for circuit-
ry modifications made by the customer
or by any third party manufacturer .
Section 4 - Controls
Dimly Lit
Red LED
Mode, One LED Dimly Lit
Brigtly Lit
Red LEDs
LEDs Brightly Lit
WARNING
Any modifications to the Ac-
tivation Switch (also known
as the Operate Switch) circuit
must comply with all OSHA
Page 45