Pre-Weld - Dukane i220 User Manual

iQ Series
Ultrasonic Integrated Press System i 220 User's Manual

PRE-WELD

The PRE WELD menu is shown in Figure 5-9. The selected
mode is highlighted (MANUAL PRESS). To change to a
different mode, move arrow to desired mode, and press
ENTER.
The PRE WELD menu shown in Figure 5-10 shows the
PRE-TRIGGER menu
The two choices are DISABLED and START OF CYCLE
The PRE WELD menu shown in Figure 5-11 shows the
PRE-TRIGGER menu with START OF CYCLE selected
as the pre-trigger TYPE
The PRE WELD menu shown in Figure 5-12 shows the
PRE-TRIGGER menu
TYPE
as the pre-trigger .
can be adjusted. In the example shown in the figure, 20%
can be raised by pressing the + (plus) key. (Since amplitude
range is 20% -100% this value can not be lower than 20%.)
and lowered by pressing the - (minus) key.
Once the amplitude value has been decided, press ENTER
to accept it, or press CANCEL to abort and return to the
previous amplitude value.
Page 54
.
.
START OF CYCLE
with
In addition, pre-trigger amplitude
MODE
PRE-TRIGGER
TRIGGER
AMP
Figure 5-9
MODE
.
PRE-TRIGGER
TRIGGER
AMP
Figure 5-10 Pre Weld Menu, Pre-Trigger Menu
MODE
PRE-TRIGGER
TRIGGER
AMP
selected
Figure 5-11 Pre Weld Menu, Pre-Trigger Menu, Start
MODE
PRE-TRIGGER
TRIGGER
AMP
Figure 5-12 Pre Weld Menu, Pre-Trigger Menu,
MANUAL PRESS
MANUAL PRESS
AUTOMATED PRESS
PRESS ENTER TO SELECT
PRE POST
WELD LIMITS SETUPS
SETUP
WELD WELD
Pre Weld Menu, Mode is Manual Press
DISABLED
START OF CYCLE
PRESS ENTER TO CHANGE
PRE POST
WELD LIMITS SETUPS
SETUP
WELD WELD
TYPE
AMPLITUDE
PRESS ENTER TO CHANGE
PRE POST
WELD LIMITS SETUPS
SETUP
WELD WELD
of Cycle Selected as Type
TYPE
AMPLITUDE
PRESS ENTER TO ACCEPT
PRESS CANCEL TO ABORT
PRE
POST
WELD LIMITS
SETUPS
SETUP
WELD WELD
Amplitude Adjustment
Dukane Manual Part No. 403-594-02
ONLINE
OPERATE LIVE
ONLINE
OPERATE LIVE
ONLINE
START OF CYCLE
20%
LIVE
OPERATE
ONLINE
START OF CYCLE
20%
20%
LIVE
OPERATE
Continued