Dukane i220 User Manual page 61

If PRE-TRIGGER is enabled in the PRE-WELD menu,
then PRE-TRIGGER amplitude is available. See Figure
5-9 on the next page.
Press the AMP soft key when:
• PRE-TRIGGER is enabled for START OF CYCLE, and
• TRIGGER selection is POWER.
Then the display shown in Figure 5-7 to the right will be
seen.
This menu has START as the top soft key. The value last
accessed is highlighted and ready to be changed. In the ex-
ample shown in Figure 5-7, that is WELD > AMPLITUDE.
For more information about Trigger by Power, refer to our
Application Note 506 on the Dukane website at: http://
www.dukane.com/us/DL_ApplData.asp
If AFTERBURST is enabled in the POST WELD menu,
then the AFTERBURST soft key is also displayed as
shown in Figure 5-8 to the right. The parameter value last
accessed will be highlighted and will be ready to change.
Dukane Manual Part No. 403-594-02
Continued from Previous Page
Figure 5-6
Figure 5-7
Figure 5-8
PRE-TRIGGER
AMPLITUDE
WELD
PRE POST
AMP WELD
WELD WELD
Setting Weld Amplitude, Pre-Trigger
Available
START
AMPLITUDE
WELD
PRE
POST
AMP WELD
WELD WELD
Setting Weld Amplitude
START
AMPLITUDE
WELD
AFTERBURST
PRE POST
AMP WELD
WELD WELD
Setting Weld Amplitude with Afterburst
Enabled
NOTE
Amplitude Range = 20 -100%
Section 5 - Operation
Online
100%
LIMITS SETUPS LIVE
OPERATE
SETUP
ONLINE
100%
PRESS ENTER TO ACCEPT
PRESS CANCEL TO ABORT
LIMITS LIVE
SETUPS OPERATE
SETUP
ONLINE
PRESS ENTER TO CHANGE
LIMITS SETUPS OPERATE LIVE
SETUP
Page 53