Power Inlet Options - Dukane i220 User Manual

iQ Series
Ultrasonic Integrated Press System i 220 User's Manual

Power Inlet Options

120V Systems for North America and
Japan
120V systems for North America and Japan have a fixed
(non-detachable) power cord.
This option is available on presses with power ratings
of 1200 watts or less and with operating frequencies of
20kHz, 30kHz, or 40kHz.
See Table 11-II in Section 11, Specifications.
Electrical Safety
120V Power Ground
For safety, the power cords used on all Dukane prod-
ucts have a three-prong, grounding-type plug.
Approved 2 pole, 3 wire grounding
receptacle HUBBELL No. 5262 or
equivalent to NEMA 5–15R or 5–20R
Figure 6 - 1 Example of 120 Volt,
Grounded, 3-Prong Receptacle
Page 74
If you have a two-prong elec-
trical receptacle, we strongly
recommend that you replace
it with a properly grounded three-prong
type. Have a qualified electrician replace
it following the National Electric Code and
any local codes and ordinances that apply.
If there is any question
about the grounding of
your receptacle, have it
checked by a qualified
electrician. Do not cut off the power cord
grounding prong, or alter the plug in any
way. If an extension cord is needed, use
a three-wire cord that is in good condi-
tion. The cord should have an adequate
power rating to do the job safely. It must
be plugged into a grounded receptacle.
Do not use a two-wire extension cord with
this product.
Dukane Manual Part No. 403-594-02
CAUTION
CAUTION