Dukane i220 User Manual page 24

iQ Series
Ultrasonic Integrated Press System i 220 User's Manual
Lockout/Tagout
Procedure to use BEFORE making any internal
adjustments to the i220 press:
1. Push the press AC power switch/breaker to the OFF
position.
2. Unplug the press electrical cord from its source.
3. Authorized personnel apply a lockout/tagout
(LOTO) device to the plug end of the press
electrical cord. Using a typical clam shell type
LOTO device:
1) Open the clam shell.
2) Place the electrical cord plug end inside
the shell.
3) Close the shell.
4) Secure the shell with its lock, and lock it.
4. Wait a minimum of five minutes for the press to
discharge its electrical energy.
5. After taking these steps, make the necessary
adjustments.
Assuming the press is being put back into service.
Procedure to use AFTER making any internal
adjustments to the i220 press:
1. Authorized personnel remove the lockout/tagout
device from the plug end of the electrical cord.
Using a typical clam shell type LOTO device:
1) Unlock the protective shell.
2) Open the shell, exposing the electrical cord
end.
3) Remove the LOTO device, and set it aside.
2. Plug the press electrical cord into its AC power
source.
3. Push the press AC power switch/breaker to the ON
position.
Page 16
Continued from Previous Page
Utilities
Provide for electricity to meet the equipment
specifications as shown in Section 11, Specifications.
contamination or moisture can coat or
clog the transducer. This can result in
premature failure of the transducer.
Air pressure is determined by the
application, transducer power draw
and ambient air temperature.
Placement
Check that enough space has been set aside for the
installation. Equipment dimensions are shown in Section
11, Specifications.
CAUTION
If transducer cooling air
is used, this compressed
air must be clean, dry and
oil free. Any particulate, oil
Dukane Manual Part No. 403-594-02