Operate - Dukane i220 User Manual

iQ Series
Ultrasonic Integrated Press System i 220 User's Manual

OPERATE

Figure 5-29 Operate Screen
When the press is powered up, there is an initial screen
that shows system information. That is followed by the
Operate screen as shown in Figure 5-29 above.
This is a display only screen. The values displayed are
from the last weld cycle. The operator can access this
screen by pressing the OPERATE hot key.
The process characteristics shown in Figure 5-48 above
are the ones where part limits have been enabled, or are
those that have been selected to display.
As an example, here is a list of all possible characteristics
that a distance press could have. (If distance is not sup-
ported, then the distance related characteristics would not
be available.)
Weld Time
Peak Power
Energy
Weld Distance
Weld End Position
Page 60
PART COUNT
DOWNSTROKE TIME
WELD TIME
ENERGY
DISTANCE
END POSITION
PRE
AMP WELD
WELD
Online/Offline/E-Stop Status
0.000s
0.000s
0.0J
0.0000in
0.0000in
POST
LIMITS
SETUPS OPERATE
SETUP
WELD
Process Characteristics
with Corresponding Values
System Power
Output Level
ONLINE
0
LIVE
Dukane Manual Part No. 403-594-02