Post-Weld - Dukane i220 User Manual

POST-WELD

The POST WELD menu seen in Figure 5-20, shows the
display with the mode set either to MANUAL PRESS or
AUTOMATED PRESS.
When TIME has been selected as the HOLD control meth-
od, the menu appears as shown in Figure 5-21 to the right.
Note that TIME is highlighted, ready to be changed.
The menu in Figure 5-22 at the right shows that AFTER-
BURST is disabled.
The menu to the right in Figure 5-23 is displayed when
AFTERBURST is enabled.
Values for afterburst amplitude, afterburst delay and after-
burst duration should be entered.
Figure 5-23 shows the entry box for afterbust amplitude
is highlighted.
Dukane Manual Part No. 403-594-02
HOLD
AFTERBURST
PRE
AMP WELD
WELD
Figure 5-20 Post Weld Menu
HOLD
AFTERBURST
PRE
AMP WELD
WELD
Figure 5-21 Post Weld Menu, Time Setting
HOLD
AFTERBURST
PRE
AMP WELD
WELD
Figure 5-22 Post Weld Menu, Afterburst Disabled
HOLD
AFTERBURST
PRE
AMP WELD
WELD
Figure 5-23 Post Weld Menu, Afterburst Enabled
Section 5 - Operation
ONLINE
DISABLED
TIME DISABLED
DISABLED
USE +/- TO SELECT
PRESS ENTER TO CHANGE
POST
LIMITS
SETUPS OPERATE
SETUP
WELD
DISABLED
TIME
PRESS ENTER TO ACCEPT
PRESS CANCEL TO ABORT
POST
LIMITS SETUPS OPERATE
SETUP
WELD
AFTERBURST DISABLED
PRESS ENTER TO CHANGE
POST
LIMITS SETUPS OPERATE
SETUP
WELD
AFTERBURST ENABLED
AMPLITUDE
|||||
DELAY
DURATION
PRESS ENTER TO ACCEPT
PRESS CANCEL TO ABORT
POST
LIMITS
SETUPS OPERATE
SETUP
WELD
Page 57
LIVE
ONLINE
0.000s
HO
AF
LIVE
AM
ONLINE
LIVE
ONLINE
100%
0.000s
0.000s
LIVE