Hot Keys - Dukane i220 User Manual

iQ Series
Ultrasonic Integrated Press System i 220 User's Manual

Hot Keys

(8)
Each of the eight hot keys under the display, when
pressed, brings up one of these portions of the menu:
•
AMP - Adjust amplitude for Weld, Pre-Trigger
and Afterburst portions of the weld cycle.
•
PRE-WELD - Select operating Mode; enable or
disable Pre-Trigger; and, select Trigger type, trig-
ger maximum time, and trigger delay.
•
WELD - Choose weld type (time, energy, dis-
tance, position or ground detect).
•
POST WELD - Set parameters for Hold and
Afterburst parts of the cycle.
•
LIMITS - Set which weld characteristics to be
displayed, and which will have their bad part part
limits enabled.
•
SETUPS - This is a display only screen show-
ing the setup (weld parameters).
•
OPERATE - This is a display-only screen
showing cycle data from the last cycle. Only those
selected to be displayed or have process limits set
will be shown.
•
LIVE - This is a display-only screen showing real
time Amplitude, Power, Operating Frequency,
and Position. (If position is not supported, it is not
displayed.)
See the next section, OPERATION for more detail on
the functions of these hot key sub-menus.
Page 38
NOTE
The white bar along the bottom of the LCD
display is positioned above the Hot Key
menu that is being displayed.
Dukane Manual Part No. 403-594-02