Unit Preparation - Ko Propo EX-10 Eurus Instruction Manual

Unit preparation

1.
Install receiver, servo, ESC (when using with electric car) and connect cables. Install receiver
noting anti-noise measures.
Read instructions included with servo and speed controller before connection and usage.
2.
IInstall batteries (R6/AA/UM3 size batteries x 8) to transmitter, then install running battery to
electric R/C car. For gas R/C car, install
receiver batteries.
3.
Register the transmitter to the receiver to complete "pairing(as follows "How to
pairing")
4.
Adjust steering and throttle/brake settings
5.
Adjust failsafe.
How to pairing
1.Install the RF-902S module in the transmitter and raises
the antenna.
2.While the set button of module is pushed, power of the
transmitter is turned on. At this time the LED light of
module lights up.
3.After approximately 3 seconds, the LED light will go out. When
LED goes out is verified, please release the set button.
4.The Receiver is brought close to the transmitter (within 1M).
5.While pressing the pairing button on the receiver, turn ON the
power source.
6.Release the pairing button when the LED indicator lights up and
the pairing is completed. Please turn off the power of the
transmitter and the receiver.
If the pairing fails it may be due to a wireless LAN, microwave oven or
someone else trying to pair at the same time. Please move to another
location where you can try the pairing again.
How to pairing
1.Install the RF-902SM module in the transmitter and raises
the antenna.
2.While the set button of module is pushed, power of the
transmitter is turned on. At this time the LED light of
module lights up.
3.After approximately 3 seconds, the LED light will go out.
When LED goes out is verified, please release the set
button.
4.The chassis is brought close to the transmitter (within
1M).(As for a detailed procedure, please refer to the
instruction manual of the chassis.)
5.While pressing the pairing button on the chassis, turn ON
the power source.
6.Release the pairing button when the LED indicator lights up
and the pairing is completed. Please turn off the power of
the transmitter and the receiver.
If the pairing fails it may be due to a wireless LAN, microwave oven or
someone else trying to pair at the same time. Please move to another
location where you can try the pairing again.
Note polarity and install fresh batteries. Depleted batteries may deteriorate radio power and
cause problems.
Case of RF-902S
Case of RF-902SM (for Mini-Z)
lights up
within 1M
from Battery
Receiver
LED of
light ON
lights up
while pressing
the setup button
Within 1M
chassis
Complete
LED of
light ON
Complete
POWER ON
ON
13