Pairing (For General Receiver) - Ko Propo EX-II Instruction Manual

● Pairing (For general receiver)
Case without the Xpansion unit
※ Refer to p.25 pairing Operation in the case of using
the Xpansion unit.
In order for the receiver to operate, it must store the
transmitter's unique ID in its memory in a process
called "pairing." Even if a single transmitter is used
to control multiple receivers, each receiver must go
through the pairing process with the transmitter before
being used for the first time.
※ Please adjust the Modulation mode before
pairing.(p.10) A receiver does not work
normally in different mode.
1.
Preparing the Transmitter
① While pushing the ET2 lever up, power on.
Power ON
ET2
② When the ET2 lever is released, the LED turns of
<France mode pairing ＞
FRANCE mode pairing is possible when the ET2
lever is released after LED turns off. Please use
this feature if the situation is needed.
ET2
EX-2 LED lights up again (indicating transmitter
is transmitting the pairing signal.)
2.
Preparing the Receiver
① Connect the receiver power
source while pressing the setup
button.
② Check that the receiver's LED
has lit up, then release the setup
button.
③ Check that the receiver's LED
lights up again (indicating pairing
completion)
※ When pairing is complete,
pressing the ENTER key on the
transmitter will return the screen
to the previous [2.4Gband] menu.
※ Switch off the receiver, then
switch it back on again for normal
operations.
※ The preparations below are to be
carried out following the pairing
procedure.
3.
Preparations for Operation
① Switch off the receiver.
② Switch off the EX-2 main power,
then switch on EX-2 again.
③ Switch on the receiver and check
that the receiver LED is lit. If
the LED flashes, the receiver is
not getting the EX-2 signal and
the pairing procedure should be
repeated.
During this process, your car may become uncontrollable
if the ESC has not been adjusted. As a precaution, set
your car so that its wheels do not touch the ground.
Pairing procedures may not go smoothly if there
are wireless LAN, microwave ovens, or other users
conducting pairing procedures nearby. In this case, move
some distance away or wait a while before attempting the
pairing procedure again.
If the mode is changed（General or France), please
conduct pairing procedures with the receiver you are
using again.
13
BATT
Lit LED
Lit LED
Flashing LED