Seat Mii 2013 Owner's Manual page 25

With the ignition switched on, and memory 1 or 2 displayed, briefly press
to change from one memory to another.
OK
The memory stores the values for the journey and the con-
sumption from the moment the ignition is switched on un-
Trip memo-
til it is switched off again.
ry (for a
If the journey is broken for more than 2 hours, the memory
1
single jour-
is automatically erased. If the journey is continued in less
ney).
than 2 hours after the ignition is switched off, the new da-
ta is added to the data already stored in the memory.
The memory stores the values of any number of journeys,
until it counts a total of 19 hours and 59 minutes of driv-
Total mem-
ing, or 1999.9 km or miles of driving, depending on the
2 ory (for all
type of instrument panel fitted. On reaching either of these
journeys).
limits, the memory is automatically erased and starts to
count from 0 again.
Possible displays
Menu Function
Current time in hours (h) and minutes (min).
Time
Journey duration This indicates the hours (h) and minutes (min)
since the ignition was switched on.
Current fuel consump- The current fuel consumption display operates
throughout the journey, in litres/100 km; and with
tion
the engine running and the vehicle stopped, in li-
tres/hour.
Average fuel consump- After turning on the ignition, average fuel con-
tion sumption in litres/100 km will be shown after trav-
elling approximately 100 metres. Otherwise hori-
zontal lines are displayed. The value shown is up-
dated approximately every 5 seconds.
Distance to empty (the Approximate distance in km that can still be travel-
distance you can trav- led with the fuel remaining in the tank, assuming
el with the remaining the same style of driving is maintained. This is cal-
fuel) culated using the current fuel consumption.
Vehicle diagram Prior to a journey...
Menu
Distance covered
Average speed
Digital display of
speed
Liquid coolant temper-
ature digital display
Warning at --- km/h
Changing between display modes
● Press the rocker switch in the windscreen wiper lever.
Storing a speed for the speed warning
● Select the display
● Press
switch off the warning.
● In addition, set the required speed by pressing the rocker switch on the
windscreen wiper lever or buttons
wheel for 5 seconds. Next, press
speed is stored and the warning activated.
● To switch off, press
Manually erasing memory 1 or 2
● Select the memory to be erased.
● Press and hold the eject button
While driving Care, cleaning and mainte-
nance
Function
Distance travelled, after ignition is switched on, in
km.
After starting the ignition, the average speed will
be shown after a distance of approximately 100
metres has been travelled. Otherwise horizontal
lines are displayed. The value shown is updated
approximately every 5 seconds.
Current speed displayed digitally.
Digital display of the current temperature of the en-
gine liquid coolant.
If the stored speed is exceeded (between
30-250 km/h, or 18-155 mph), an audible warning
is given together with a visual warning.
Speed warning at --- km/h .
on the windscreen wiper lever to store the current speed and
OK
or on the multifunction steering
 
again or wait a few seconds. The
OK
. The stored speed is deleted.
OK
for approximately 2 seconds.
OK
If and when
Instrument panel 23

Technical Data