Seat Mii 2013 Owner's Manual page 177

Opening the bonnet
● Before opening the bonnet, make sure that the windscreen wiper arms
are in place against the windscreen ⇒ .
● Pull the release lever in the direction of the arrow
1
bonnet is released from the lock carrier by a spring mechanism ⇒
● Lift the bonnet up slightly while pressing the release lever
direction of the arrow to completely open the bonnet.
● Take out the bonnet support rod from its clip in the direction of the ar-
row C and place it in the corresponding open position
3
Closing the bonnet
● Slightly lift the bonnet ⇒
● Take out the bonnet support rod from the opening catch
it into its clip C in the opening catch.
3
● Let the bonnet fall from a height of 30 cm into its clip; Do not apply pres-
sure!
If the bonnet is not correctly closed, open it once again and close it correct-
ly.
The bonnet is correctly closed when it is flush with the corresponding parts
on the bodywork.
WARNING
If the bonnet is not correctly closed, it could suddenly open while driving
leaving the driver without visibility. This could result in serious accident.
● After closing the bonnet, always check that it is properly secured by
the locking mechanism in the lock carrier piece. The bonnet must be
flush with the surrounding body panels.
● While driving, if you notice that the bonnet is not correctly closed
then stop immediately and close it correctly.
● Only open and close the bonnet when there is nobody within its
range.
Vehicle diagram Prior to a journey...
⇒ f ig. 104
A. The
.
B in the
2
D (arrow).
4
.
D and insert
4
While driving
CAUTION
● To avoid damage to the bonnet and to the windscreen wiper arms, only
open the bonnet when the windscreen wipers are in place against the wind-
screen.
● Before driving, always lower the windscreen wiper arms.
Care, cleaning and mainte- If and when
nance
In the engine compartment 175

Technical Data