Seat Mii 2013 Owner's Manual page 263

Removing the tail light units
Always take the checklist into account and take the necessary ac-
1.
tions ⇒ p age 256.
Open the rear lid ⇒ p age 40.
2.
3. Carefully remove the cover
Pull the release in the connector
3
4.
⇒ f ig. 148
B. Use the screwdriver in the vehicle tool kit.
5. Press position and remove the connector
4
6. Unscrew the wing nut
Remove the tail light from the bodywork by carefully pulling back-
7.
wards.
8. Disassemble the tail light unit and place it on a flat, clean surface.
To change the bulb
Unlock the bulb holder locking tab (arrow)
9.
the bulb holder from the tail light.
10. Replace the faulty bulb by a new identical bulb
Place the lamp holder in the tail light unit. The attachment tabs (ar-
11.
row) should audibly click into place
Assembling the tail light units
12. Carefully insert the tail light unit into the opening in the bodywork.
Support the tail light with one hand in the assembly position and
13.
securely screw the wing nut with the other
Ensure that the tail light unit has been correctly fitted and is firmly
14.
secured.
Insert the connector
2
15.
on the connector in the opposite direction to the arrow
16. Insert the cover. The cover should lock into place.
17. Close the rear lid ⇒ p age 40.
Vehicle diagram Prior to a journey...
⇒ f ig. 148
towards the lever A.
1
in the direction of the arrow
2
⇒ f ig. 148
B.
2
⇒ f ig. 148
B.
5
⇒ f ig. 149
C and remove
⇒ f ig. 149
D.
⇒ f ig. 149
C.
⇒ f ig. 148
B.
5
into the bulb holder and press the lock
⇒ f ig. 148
While driving
Changing the number plate light
3
B.

Care, cleaning and mainte-
nance
Practical information
Fig. 150 On the rear
bumper: Remove number
plate light.
Fig. 151 Number plate
light: Remove the lamp
holder.
If and when Technical Data
261
