Seat Mii 2013 Owner's Manual page 242

240 Practical information
Full hubcaps
Removing the full hubcap
● Take the wheel brace and the wire hook from the vehicle tool kit
⇒ p age 237.
● Hook the wire through one of the grooves on the hubcap.
● Insert the wheel brace onto the wire hook
cap in the direction shown by the arrow.
Fitting hubcaps
Press the hubcap against the wheel so that the space for the valve fits over
the tyre valve. Make sure that the hubcap is correctly fitted all the way
around the wheel. If you are using an anti-theft wheel lock, screw it in the
opposite position to the valve.
Wheel bolt caps
Fig. 134 Removing the
full hubcap.
● Take the wire hook from the vehicle tool kit ⇒ p age 237.
● Insert the wire hook in the cap through the opening
outwards in the direction of the arrow.
The caps protect the wheel bolts and should be remounted after changing
⇒ f ig. 134
and pull the hub
the tyre.
The anti-theft wheel locking bolt has a special cap. This cap only fits on an-
ti-theft locking bolts and is not for use with standard wheel bolts.

Fig. 135 Removing the
wheel bolt caps.
⇒ f ig. 135
and pull
