Seat Mii 2013 Owner's Manual page 251

1)
Bottle of sealant
10
Spare tyre valve
11
The valve insert remover has a gap at the lower end for a valve insert.
1
The valve insert can only be screwed or unscrewed in this way. This also ap-
plies to its replacement part
11
Preparation
Checklist
Before filling a tyre, complete the following operations in the order given
⇒
:
1. In the event of a puncture, park the vehicle as far as possible from
traffic and on flat, suitable ground.
Apply the handbrake firmly ⇒ p age 128.
2.
Stop the engine and remove the key from the ignition ⇒ p age 119.
3.
Manual gearbox: Select a gear ⇒ p age 124.
4.
5. Have all vehicle occupants get out of the vehicle and wait in a safe
place (for example, behind the safety barrier).
6. Switch on the hazard warning lights and set the warning triangle in
position ⇒ p age 231. Observe legal requirements.
7. Check whether a repair is possible using the Tyre Mobility Set
⇒ p age 247
8. If the luggage compartment is full: take the baggage out of the vehi-
cle.
9. Remove the tire mobility set from the luggage compartment.
⇒ f ig. 141
10. Apply the sticker
panel where it can be seen clearly.
Do not remove foreign objects, e.g. screws or nails, from the tyre.
11.
1)
A compressor may also be included.
Vehicle diagram Prior to a journey...
.
from the tire mobility set to the dash
2
While driving
WARNING
Failure to follow the checklist prepared for your own safety could lead to
accidents and severe injuries.
● Always complete the operations given in the checklist and observe

the general rules of safety.
Sealing and inflating a tyre
Sealing a tyre
● Unscrew the tyre valve cap.
● Use the corresponding enclosed extractor
tyre valve insert. Place the valve insert on a clean surface.
● Vigorously shake the sealant bottle
⇒ f ig. 141
● Screw the inflator tube
clockwise direction. The seal on the mouth of the bottle moves automatical-
ly.
● Remove the lid from the filling tube
end of the tube into the tyre valve.
● Hold the tyre sealant can upside down and fill the complete contents of
the can into the tyre.
● Remove the tyre sealant bottle from the valve.
● Screw the valve insert again with the corresponding enclosed extractor
⇒ f ig. 141
into the tyre valve.
1
Inflating the tyre
● Securely screw the tyre inflator tube
to the tyre valve.
● Check whether the air bleed screw
Care, cleaning and mainte- If and when
nance
Practical information

⇒ f ig. 141
to unscrew the
1
⇒ f ig. 141
for several seconds.
10
securely into the sealant bottle in a
3
⇒ f ig. 141
and screw the open
3
⇒ f ig. 141
of the compressor in-
5
⇒ f ig. 141
is closed.
7 
Technical Data
249