Seat Mii 2013 Owner's Manual page 157

flashes Possible cause
The Start-Stop system is not

available.
Some warning and control lamps will light up briefly when the ignition is
switched on to check certain functions. They will switch off after a few sec-
onds.
WARNING
If the warning lamps are ignored when they light up, the vehicle may
stall in traffic and cause accidents and severe injuries.
● Never ignore the warning lamps.
● Stop the vehicle at the next opportunity.
CAUTION
Failure to heed the control lamps when they light up may result in damage
to the vehicle.
Vehicle diagram Prior to a journey...
Start-Stop system
Solution
Contact a Specialised
workshop.
With the Start-Stop system enabled, the engine is automatically stopped
when the vehicle is at a standstill. It will start again automatically as re-

quired.
This function remains enabled while the ignition is switched on. The instru-
ment panel display shows information on the current status ⇒ p age 154.
Disconnect the Start-Stop system by hand whenever crossing water.
Vehicles with a manual gearbox
● When the vehicle is stopped, put it into neutral and release the clutch
pedal. The engine will stop.
● To restart, simply engage the clutch.
Important conditions for the engine to stop automatically
● The driver's seat belt must be fastened.
● The driver door must be closed.
● The bonnet must be closed.
While driving Care, cleaning and mainte-
nance
Driver assistance systems
Fig. 97 At the top of the
centre console: Start-
Stop system button.
If and when Technical Data
155
