Setting Items Of Ieee 802.1X For Ethernet - Ricoh 3406WD Setting Manual

1. Log in to Web Image Monitor in the administrator mode.
2. In the menu area, click [Configuration].
3. Under "Security", click [SSL/TLS].
4. Click [Active] for the protocol version used in "SSL/TLS".
5. Select the encryption communication mode for "Permit SSL/TLS Communication".
6. Click [OK].
The SSL setting is enabled.
7. Click [OK].
8. Click [Logout].
9. Quit the Web Image Monitor.
• If you set "Permit SSL/TLS Communication" to [Ciphertext Only], enter " https://(the machine's IP
address or host name)/" to access the machine.

Setting Items of IEEE 802.1X for Ethernet

1. Log in to Web Image Monitor in the administrator mode.
2. In the menu area, click [Configuration].
3. Under "Security", click [IEEE 802.1X].
4. In "User Name", enter the user name set in the RADIUS server.
5. Enter the domain name in "Domain Name".
6. Select "EAP Type". Configurations differ according to the EAP Type.
EAP-TLS
• Make the following settings according to the operating system you are using:
• Select [On] or [Off] in "Authenticate Server Certificate".
• Select [On] or [Off] in "Trust Intermediate Certificate Authority".
• Enter the host name of the RADIUS server on "Server ID".
• Select [On] or [Off] in "Permit Sub-domain".
LEAP
• Click [Change] in "Password", and then enter the password set in the RADIUS server.
EAP-TTLS
• Click [Change] in "Password", and then enter the password set in the RADIUS server.
• Click [Change] in "Phase 2 User Name", and then enter the user name set in the RADIUS server.
• Select [CHAP], [MSCHAP], [MSCHAPv2], [PAP], or [MD5] in "Phase 2 Method".
Configuring IEEE 802.1X
275
7