Ricoh 3406WD Setting Manual page 154

4. Monitoring and Configuring the Machine
msh> set rsh6
msh> set diprint
msh> set diprint6
msh> set web
msh> set snmp
msh> set ssl
msh> set ssl6
msh> set nrs
msh> set rfu
4 msh> set rfu6
msh> set ipp
msh> set ipp6
msh> set http
msh> set http6
msh> set bonjour
msh> set bonjour6
msh> set nbt
msh> set ssdp
msh> set ssh
msh> set sftp
msh> set sftp6
msh> set wsdev
msh> set wsdev6
msh> set wsprn
msh> set lltd
Configuration
• Enter "up" to enable the protocol, and enter "down" to disable the protocol.
You can set the protocol to "active" or "inactive".
msh> set ipv4 {up|down}
• If you disable IPv4, you cannot use remote access after logging out. If you did this by mistake,
you can use the control panel to enable remote access via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http, bonjour, wsdev, and
sftp.
msh> set ipv6 {up|down}
152