2. Connecting the Machine
Connecting to the Ethernet Interface
This section describes how to connect an Ethernet cable to the Ethernet interface.
• If the main power switch is on, turn it off.
2
• Use the following Ethernet cables.
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
1.
Make a loop 3 cm (1.2 inch) (1) from the end of the Ethernet cable and attach the included
ferrite core to the loops as shown.
1
2.
Make sure the main power is switched off.
3.
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
4.
Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
66
BZU007
CBB010