Switching The Server On And Off - PRIMERGY TX300 S3 Operating Manual

Switching the Server On and Off

5.3 Switching the Server On and Off
V
CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see
shooting and Tips" on page
The power button does not disconnect the server from the mains voltage.
To completely disconnect it from the mains voltage, remove the power
plug(s) from the socket(s).
Switching the server on
– Starting up for the first time:
Ê Press the ON/OFF button (position 1 in
Ê Insert the ServerStart disc 1 and/or an installation disk in the corre-
sponding drive.
Ê Follow the on-screen instructions (see also
ServerStart" on page 73
on page 74).
– System already installed:
The Power on indicator (position 2 in
(standby mode).
Ê Press the ON/OFF button (position 1 in
The server is switched on, performs a system test and boots the
operating system.
Switching the server OFF
Power on indicator (position 2 in
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power on indicator lights up orange.
I
If the server does not switch off immediately, hold the ON/OFF button
down for at least four seconds or send a corresponding control signal.
70
79).
figure 22 on page
or section "Configuration without ServerStart"
figure 22 on page
figure 22 on page
figure 22 on page
Operating Manual
Starting Up and Operation
chapter "Trouble-
61).
section "Configuration with
61) lights orange
61).
61) lights green.
TX300 S3