Remove The Hot-Pluggable Pci Board From The Removal Tool - PRIMERGY TX300 S3 Operating Manual

Hot-pluggable PCI boards
Ê Activate the board either using the relevant software or by pressing the
waveguide (b).
The power indicator for the hot-plug PCI slot (see
flashes green. The slot is in an enable sequence.
Ê Wait until the power indicator is lit and steady. The slot is now powered on.
I
If the boards do not match, the new board will not be commissioned
(see section "Hot-plug PCI voltage display does not light up after the
board has been replaced" on page
Ê Replace the left side cover (floorstand model) or the housing cover (rack
model) (see section "Opening/Closing the Housing" on page
8.4.2 Remove the hot-pluggable PCI board from the
removal tool
Figure 35: Remove the hot-pluggable PCI board from the removal tool
Ê Lift the movable green engaging hooks no more than about 1 mm (1), until
the PCI board is completely released.
Ê Remove the PCI board from the removal tool (2).
102
84).
1
1
2
Operating Manual
Hot plug components
table 2 on page 68)
107).
1
TX300 S3