Troubleshooting And Tips; Power On Indicator Remains Unlit - PRIMERGY TX300 S3 Operating Manual

Table of Contents

Advertisement

7

Troubleshooting and Tips

V
CAUTION!
Observe the safety information in the "Safety" manual and in the
"Hardware Installation" on page
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
7.1

Power On Indicator Remains Unlit

The power-on indicator remains dark after you switch on your device.
Power cable incorrectly connected
Ê Make sure that the power cable(s) is/are correctly connected to the server
and the grounded socket(s).
Power supply overloaded
Ê Disconnect the server power plug(s) from the power socket(s).
Ê Wait a few seconds before you plug it/them into the grounded socket(s)
again.
Ê Switch on your server.
TX300 S3
31.
Operating Manual
chapter
79

Advertisement

Table of Contents
loading

Table of Contents