Replacing Hot Pluggable Power Supply Units - PRIMERGY TX300 S3 Operating Manual

Table of Contents

Advertisement

Hot-plug power supply units
8.1.1

Replacing Hot Pluggable Power Supply Units

Figure 26: Unlocking and removing the power supply unit
V
CAUTION!
Before replacing a non defective power supply unit in a non-redundant
configuration (only one power supply unit present) the server must be
switched OFF.
Ê Remove the cable from the installed power supply unit.
Ê Push the green catch in the direction of the arrow (1) while pulling the power
supply unit out of its mounting location (2) by the handle.
Ê Slide the new power supply unit into the empty slot until it clicks into place.
I
Make sure that the power supply unit engages correctly in the
mounting location and is locked in position.
This is the only way to avoid the power supply unit being shaken out
of its mountings and damaged during transportation.
Ê Connect the newly installed power supply unit.
88
Operating Manual
Hot plug components
TX300 S3

Advertisement

Table of Contents
loading

Table of Contents