Removing The Pci Slot Cover From The Removal Tool - PRIMERGY TX300 S3 Operating Manual

Hot-pluggable PCI boards
8.4.4.1

Removing the PCI slot cover from the removal tool

Free hot-plug PCI slots are provided with a slot cover that is mounted on the
removal tool, and these must be removed before the next hot-pluggable PCI
board is installed.
Figure 37: Removing the PCI slot cover from the removal tool
Ê Lift the movable green engaging hooks no more than about 1 mm (1), until
the PCI board is completely released.
Ê Remove the slot cover (2).
V
CAUTION!
Keep the slot cover in a safe place. If the hot-pluggable PCI board is
removed again and not replaced with a new one, the slot cover must
be reinstalled in the removal tool due to cooling, to comply with appli-
cable EMC regulations (regulations on electromagnetic compatibility)
and to protect against fire.
Ê Push the engaging hooks down until they disengage from the removal tool
(see figure 35 on page
To mount the slot cover in the removal tool, proceed as for installing a hot-
pluggable PCI board (see
removal tool" on page
106
1
1
2
102), and keep them in a safe place.
section "Place the hot-pluggable PCI board in the
103).
Operating Manual
Hot plug components
TX300 S3