Table of Contents
Advertisement
Hardware Installation
4.5
Connecting the Server to the Mains
In its basic configuration level the server has a hot-pluggable power supply unit.
A second hot pluggable power supply unit can be added to achieve a redundant
power supply. If a defect occurs in one power supply unit, the respective other
power supply unit ensures unimpaired further operation.
V
CAUTION!
The device automatically adjusts itself to a mains voltage between
100 V - 240 V. Make sure that your local mains voltage is within this
range.
Figure 19: Connecting the Server to the Mains
Ê Connect the insulated connector of the power cable to power supply unit of
the server (1), and the power plug to a grounded mains outlet (2) of the in-
house mains and/or into the mains socket strip of the rack (see Technical
Manual of the rack).
I
If the server has two hot pluggable power supply units, the server can be
connected to the mains with phase redundancy.
In this case the two power supply units are directly connected either to
two different phases or to two different power circuits of the in-house
mains.
TX300 S3
Connecting the Server to the Mains
1
1
Operating Manual
2
2
57
Advertisement
Table of Contents
