Installation In 3Rd Party Racks - PRIMERGY TX300 S3 Operating Manual

Installing/Removing the Rack Model
4.3.3

Installation in 3rd Party Racks

The procedure for installing in 3rd party racks is basically as described in
"Mounting in the PRIMECENTER/DataCenter Rack" on page 40
bracket and cable management are not installed). The following parts are
required:
– one support system on the left and one on the right (mounted)
– possibly an articulated cable guide
– possibly protective hose for fiber channel fiber optic cable
Ê Refer to the manual from the rack manufacturer for details of the mechanical
installation and the climatic conditions.
V
CAUTION!
For installation in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
I
Sometimes a number of parts of the delivered mounting kit cannot be
used because original parts of the 3rd-Party Rack are to be used.
Ê Mount the server (see
Ê Route the cables as described in the original rack manual.
48
section "Inserting the
Operating Manual
Hardware Installation
(the support
server").
TX300 S3