Wireless Zones; General Information; Zones; Range - Honeywell LyricLCP300-L Installation And Reference Manual

Hide thumbs

Table Of Contents

Table of Contents

Lyric Gateway Installation and Reference Guide

Wireless Zones

General Information

Zones

The Lyric Gateway supports up to 64 total wireless protection zones using 5800 and SiX™ Series transmitters,

and wireless keys.

Range

The built-in RF receiver can detect signals from wireless transmitters within a nominal range of 200 feet.

T T T T ransmitters

ransmitters

5800 and SiX™ Series transmitters have built-in serial numbers that must be entered into the system via

AlarmNet 360

. Each transmitter's zone number is also programmed into the system in the "Zones"

programming section. Some transmitters, such as the 5816 can support more than one "zone" (referred to as

loops or inputs). On the 5816, for example, the wire connection terminal block is loop 1; the reed contact is loop

2. Each loop must be assigned a different zone number.

For 5800 Series wireless keys such as the 5804E, 5834-4 and 5878, you must assign a unique zone number to

each individual button used on the transmitter. Each button on the transmitter also has a pre-designated loop

or input number, which is automatically displayed.

The 5816 Transmitters do n

The 5816

Transmitters do not have EOL

The 5816

Transmitters do n

feet.

ETL

The 5800PIR

The

5800PIR- - - - OD,

OD, 5800SS1,

The

5800PIR

OD,

evaluated by

evaluated by ETL

evaluated by

ETL

ETL. . . .

ETL

Transmitter Supervision

With the exception of some transmitters/keypads that may be carried off-premises (5804E, 5834-4 and

SiXFOB), each transmitter is supervised by a check-in signal that is sent to the receiver at 70–90 minute

intervals. If at least one check-in is not received from each supervised transmitter within a 12-hour period, the

"missing" transmitter zone number(s) and "Supervision" will be displayed. The supervision for a particular

transmitter in the system that may also be carried off the premises may be turned off by entering it as an

"Unsupervised" type. For additional information, refer to the "Zones" programming section in the Lyric

Gateway Quick Installation Guide (p/n 800-21668). 5800 and SiX™ Series transmitters have built-in tamper

protection and will annunciate as a fault condition if covers are removed. In Canada the RF supervision period

is 3-hours for Fire zones and 12 hours for all other zone types.

Transmitter Input Types

ansmitter Input Types

Each transmitter has one or more unique factory-assigned input (loop/5800 Series or service/SiX™ Series) ID

codes. Each of the inputs requires a programming zone (e.g., a 5804E's four inputs require four button zones).

Transmitters can be entered as one of the following types (see transmitter's instructions for appropriate

Supervision type):

Type

RF Supervised

Sends periodic check-in signals, as well as fault, restore, and low battery signals. The

transmitter must remain within the receiver's range.

RF Unsupervised

Sends all the signals that the Supervised type does, but the Gateway does not supervise

the check-in signals. The transmitter may therefore be carried off-premises.

Button

Sends only fault signals. Does not send low battery signals until activated. The

transmitter is unsupervised and may be carried off-premises.

Transmitter Battery Life

Transmitter Battery L

Batteries in the wireless transmitters may last from 4–7 years, depending on the environment, usage, and

•

the specific wireless device being used. Factors such as humidity, high or low temperatures, as well as large

swings in temperature may all reduce the actual battery life in a given installation. The wireless system can

identify a true low battery situation, thus allowing the dealer or user of the system time to arrange a change

of battery and maintain protection for that point within the system.

Button-type transmitters should be periodically tested for battery life. The 5804E, 5834-4, 5878 and SiXFOB

•

button transmitters have replaceable batteries.

Transmitter (Sensor) Firmware Upgrade

Transmitter

(Sensor) Firmware Upgrade

Transmitter

(Sensor) Firmware Upgrade

The SiX™ Series transmitters (sensors) will receive updated firmware (if required) any time that the Gateway

firmware is updated via AlarmNet 360. The Gateway will attempt to update the sensor firmware every 24 hours

after its firmware has been updated.

ot have EOL supervision of their loop wiring

ot have EOL

5800SS1, 5804E,

5804E, 5814,

5814, 5821, 5877

5800SS1,

5804E,

5814,

ife

supervision of their loop wiring, which

supervision of their loop wiring

5821, 5877 and

and 5878

5878 wireless transmitters

5821, 5877

and

5878

Description

- 12 -

, which m m m m ust

ust not exceed 3

, which

ust

wireless transmitters have not been

have not been

wireless transmitters

have not been

not exceed 3

Table of Contents

This manual is also suitable for:

Lyric lcp300-lc

Wireless Zones; General Information; Zones; Range - Honeywell LyricLCP300-L Installation And Reference Manual

Wireless Zones

General Information

Zones

Range

Transmitter Supervision

Transmitter Input Types

Transmitter Battery Life

Related Manuals for Honeywell LyricLCP300-L

Related Content for Honeywell LyricLCP300-L

This manual is also suitable for:

Table of Contents