Ending A Batch; Completing Or Aborting A Batch - Siemens SIMATIC PCS 7 OSx Operator's Manual

8.10

Ending a Batch

Completing or
Aborting a Batch
SIMATIC PCS 7 OSx 4.1.2 Operator
To end a batch, perform the steps below.
1. Select from the batch tag detail.
State
2. Select or
Complete
The end time is set to reflect the time that the
command was executed.
The option sets the end time for the batch and sends the Done
Complete
command to all units currently assigned to the batch. The
sets the end time for the batch and sends the Abort command to all units
currently assigned to the batch. Other functions built into the batch
program by the plant engineer can cause other processes to occur when the
operator selects the
Complete
NOTE: The batch uses OSx resources until
State. After selecting
available for use by another batch. After the
batch ID is removed from the Active Batch Directory.
Figure 8-11 Ending a Batch Example
option for the batch State field
Abort
or options.
Abort
, the batch tag is released to the system and is
Remove
Alarm Group:
Alarm State Sequencing:
Alarming:
(Figure
or
Complete Abort
option also
Abort
is selected for the batch
Remove
is executed, the
Remove
State:
Batch
8-11).
8-13