CHAPTER 6: ACTUAL VALUES
6.3.18 Parallel Redundancy Protocol (PRP)
The Parallel Redundancy Protocol (PRP) defines a redundancy protocol for high availability in substation automation
networks.
ACTUAL VALUES STATUS PRP STATUS
PRP STATUS
The L90 is provided with optional PRP capability. This feature is specified as a software option at the time of
ordering. See the Order Codes section in chapter 2 for details.
is a counter for total messages received (either from DANPs or from SANs) on Port A.
Total Received Port A
is a counter for total messages received (either from DANPs or from SANs) on Port B.
Total Received Port B
is a counter for total messages received with an error (bad port code, frame length too short).
Total Errors
is a counter for total messages received with an error on Port A (PRP frame, but port received through
Mismatches Port A
and LAN ID in the frame do not match).
is a counter for total messages received with an error on Port B (PRP frame, but port received through
Mismatches Port B
and LAN ID in the frame do not match).
6.3.19 TxGOOSE status
ACTUAL VALUES STATUS TxGOOSE STATUS
TxGOOSE STATUS
The L90 is provided with optional IEC 61850 capability. This feature is specified as a software option at the time
of ordering. See the Order Codes section of chapter 2 for details.
This status is relevant to R-GOOSE reception when configured for SSM or ASM reception modes. It is not relevant for GOOSE
or for R-GOOSE in unicast reception mode.
— The unicast mode of R-GOOSE transmission requires Address Resolution Protocol (ARP) for the resolution of the
ARP
network layer address into the MAC layer address. R-TxGOOSE## ARP status On indicates that ARP responses are being
received and the destination MAC address for R-GOOSE transmissions has been obtained. This status remains Off if
TxGOOSE## is not configured for R-GOOSE. It also remains Off if setting R-TxGOOSE1 DST IP is set to a multicast address. In
the case where setting R-TxGOOSE1 DST IP is configured with a unicast address and this status indicates Off, TxGOOSE##
transmission will be off, and therefore communication network diagnosis needs to be carried out.
L90 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
Total Rx Port A:
0
Total Rx Port B:
0
Mismatches Port A:
0
Mismatches Port B:
0
Total Errors:
0
R-TxGOOSE 1
ARP:
Off
R-TxGOOSE 16
ARP:
Off
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: On, Off
Range: On, Off
STATUS
6
6-11