Flexlogic; Flexlogic Operands - GE L90 Instruction Manual

CHAPTER 5: SETTINGS
— This setting sets the default state of the stream (On or Off) on power-up or restart.
R-SV CB1 SVENA DFLT
— The relay increments the Configuration revision every time the configuration is changed. This setting
R-SV CB1 CONFREV
allows the user to reset the configuration back to 1 or a value from 1 to 4294967295.
— A value from 0 through 7. The default value is 4.
R-SV CB1 PRIORITY
— The value represents the IPv4 Differentiated Services (formerly called TypeOfService) value. The
R-SV CB1 DSCP CLASS
default value is set for Expedited Forwarding (101110B (46 or 2EH). This value provides priority routing, when supported in
the routers.
— A range of values limited from 0 to 4095.
R-SV CB1 VLAN ID
— This setting allows the selection of a specific application ID for each sending device.
R-SV CB1 APPID
— This is the destination multicast IP address that is entered in Standard IPV4 address format. The valid
R-SV CB1 DEST IP
range for IPv4 is from 224.0.0.0 to 239.255.255.255. The UR does not test the address entered.
— This setting selects the level of security and authentication used, as outlined in the following table,
R-SV CB1 SECURITY
and is in the form of an enumeration as per standard. The range is 0 to 2.
Shaded settings in the table are not supported in firmware 7.0.
Table 5-22: Security
Enumeration Authentication
0 No
1 Yes
2 Yes

5.6 FlexLogic

5.6.1 FlexLogic operands

For flexibility, the arrangement of internal digital logic combines fixed and user-programmed parameters. Logic upon
which individual features are designed is fixed, and all other logic, from contact input signals through elements or
combinations of elements to contact outputs, is variable. The user has complete control of all variable logic through
FlexLogic. In general, the system receives analog and digital inputs that it uses to produce analog and digital outputs. The
figure shows major subsystems of a generic UR-series relay involved in this process.
L90 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
Encryption
No
No
Yes
FLEXLOGIC
5
5-187