Part 2: Advanced Setup; Apollo Iii Network Connection; Direct Connection - MachMotion Apollo III Manual

40 | P a g e

8 PART 2: ADVANCED SETUP

8.1 Apollo III Network Connection

The Apollo III can be connected directly to the control or via an Ethernet router. Either of the two Ethernet ports
on the Apollo III can be used. The Ethernet ports have a built in Ethernet switch so you can also use them to daisy
chain other Ethernet devices together on a local network.

8.1.1 Direct Connection

To set up the Apollo III to communicate with the control directly, the network configuration needs to be assigned a
static IP address. The default static IP configuration is defined below.
FIGURE 45 ETHERNET CONNECTOR
Location
Apollo III
Computer
TABLE 8 STATIC IP ADDRESSES
Control
Control
FIGURE 46 DIRECT NETWORK CONFIGURATION
Ethernet Ports
IP Address
192.168.0.35
192.168.0.10
Apollo III
Apollo III Using Mach3