Table of Contents
Advertisement
P a g e
| 43
FIGURE 51 VSI DEVICE MANAGER
Note: A device should show up as shown.
3. Select the device and press [Switch To Loader].
4. Click through the message windows that pop up and click on [Load File].
5. Select the .bin file from the location specified in Error! Reference source not found..
6. Press [Program Flash] and wait until it finishes programming.
7. Press [OK] when it asks to reboot to launch the new firmware.
8. Close the device manager.
The firmware should now be updated.
WARNING
Install the plugin AND download the firmware to the Apollo III. If the firmware
and plugin versions do not match, it could cause serious damage to the
machine or cause the Apollo III not to operate at all.
Apollo III Using Mach3
Advertisement
Table of Contents
