Table of Contents
Advertisement
12 |
P a g e
*Only 24V is provided on the motion controller. Any other voltage must be supplied. **Commons must be supplied externally. If the commons are using the Apollo
III power supply, each output can only source 125mA.
1.6 Drawing
Below is a drawing of the Apollo III.
FIGURE 3 - APOLLO III MOUNTING HOLES
The controller can be mounted on any solid surface that will be protected from dust and dirt. Use a minimum of
3/8 inch standoffs to prevent electrical shorts.
Scale drawing of the Apollo III and mounting case are located in Appendices, pages 83 and 85.
Hardware Star tup
To power the Apollo III, you must supply 24VDC to the power connection located at the top right of the board as
shown below. The top orange LED labeled Power will turn on.
Power LED
FIGURE 4 24V POWER CONNECTOR
Apollo III Using Mach3
Advertisement
Table of Contents
